Installing A-Pillar Lights on Your Ford Bronco

Adding A-pillar lights to your Ford Bronco is a great way to enhance your off-road visibility and give your vehicle a rugged, customized look. Follow this step-by-step guide to install A-pillar lights on your Bronco easily and efficiently.


Tools and Materials Needed

• Bronco A-pillar light kit (including lights, mounting brackets, and wiring harness)
• Socket wrench set
• Screwdrivers (Phillips and flathead)
• Wire crimper and stripper
• Electrical tape
• Zip ties
• Safety gloves and glasses

Step 1: Prepare Your Work AreaStart by parking your Bronco on a flat surface and ensuring it is turned off with the keys removed. Put on your safety gloves and glasses to protect yourself during the installation.
Step 2: Attach the Mounting Brackets

1. Locate the A-Pillar: The A-pillars are the vertical supports located between the windshield and the front doors.
2. Remove Existing Bolts: Use the socket wrench to remove the factory bolts on the A-pillars where the mounting brackets will be installed.
3. Position the Brackets: Place the mounting brackets from your light kit onto the A-pillars, aligning the holes in the brackets with the bolt holes on the vehicle.
4. Secure the Brackets: Use the socket wrench to reinsert and tighten the bolts, securing the mounting brackets firmly to the A-pillars.

Step 3: Install the A-Pillar Lights

1. Attach the Lights: Place the A-pillar lights onto the mounting brackets. Align the lights so they face the desired direction.
2. Secure the Lights: Use the screws provided in the light kit to secure the lights to the brackets. Ensure the lights are tightly fastened but still adjustable for later alignment.

Step 4: Wiring the Lights

1. Route the Wiring: Run the wiring harness from the lights down the A-pillars and into the engine bay. Make sure to route the wires away from any moving parts or sharp edges.
2. Connect to Power Source: Identify a suitable power source in the engine bay, such as the battery or fuse box. If your light kit includes a relay and switch, follow the manufacturer’s instructions for proper connection.
   • Battery Connection: Attach the positive wire (usually red) to the positive terminal of the battery and the negative wire (usually black) to the negative terminal.
   • Fuse Box Connection: If connecting to the fuse box, use an appropriate fuse tap to connect the positive wire, and ground the negative wire to a metal part of the chassis.
3. Install the Switch: If your kit includes an interior switch, run the switch wiring through the firewall into the cabin. Mount the switch in a convenient location on the dashboard.

Step 5: Test the Lights

1. Check Connections: Double-check all connections to ensure they are secure and properly insulated with electrical tape or heat shrink tubing.
2. Test the Lights: Turn on your Bronco and test the A-pillar lights using the installed switch. Adjust the angle of the lights as necessary to achieve the desired beam pattern.

Step 6: Secure and Clean Up

1. Secure Wires: Use zip ties to secure any loose wires in the engine bay and along the A-pillars. Ensure the wiring is tidy and free from any potential hazards.
2. Final Adjustments: Make any final adjustments to the positioning of the lights to ensure optimal coverage and minimal glare.

Installing A-pillar lights on your Ford Bronco is a relatively straightforward process that can significantly improve your offroad visibility and safety. By following these steps, you’ll be able to tackle nighttime trails with confidence and enjoy a well-lit adventure. With your new A-pillar lights securely in place, your Bronco is ready to illuminate the darkest paths and provide you with the ultimate off-road experience.

---